Download View/Save - Global Specialties
Transcript
RP6 ROBOT SYSTEM - APPENDIX Make sure that you check if your Hardware uses the correct voltage levels. It must be 5V TTL – if it is standard RS232 then it will be +-12V which could damage the pins. In this case you need a RS232 level shifter like the MAX232 or similar. In the same way you have to use a proper 3.3V level shifter if you use low voltage devices. If you want to use the Bootloader you have to connect MRESET to the RTS pin. The other pins are usually not required. Except maybe the VTARGET / +5V Pin for supply of level shifters. Small devices with up to 200mA power consumption can be directly powered from this pin. ADC Connectors: The figure shows the pin assignments for both free ADC channel connectors. We did not assemble these connectors and you may apply use 3-pin connectors with 2.54mm grid. Be careful in soldering and do not ruin the mainboard! If you are unexperienced with soldering, please refrain from soldering at the mainboard and prefer to start experiments by using an expansion board! You may connect any two analog or digital sensors to these free ADC channels. The sensor's output voltages are allowed to range from 0 up to 5V and the connectors provide the sensors with the 5V supply voltage. The Pinout is intended for Sharp IR distance Sensors of the GP2Dxxx Series. On the new RP6v2 there is already a 220µF electrolytic capacitor in the power supply line which is required to support the high pulse current that such sensors need. On the old RP6 it might be wise to solder a big electrolytic capacitor to the mainboard – values from 220 up to a 470µF (do not exceed this value! The capacitor's operating voltage should be bigger or equal to 16V) will be perfectly suitable for most applications. However you will probably not really need a big electrolytic capacitor, unless you are working with sensors, which require vast peak currents – e.g. the popular Sharp IR distance sensors. Decoupling capacitors (100nF) on the mainboard are suitable for short connection wires only – for long wires, these have to be directly soldered to the sensor (we advise to directly mount these capacitors at the sensor's connection pads even for short wires as well!). ATTENTION: The Pinout is NOT compatible with standard Servos! This is on purpose as you need some power supply filtering for most Serovs anyway (LC Lowpass Filter for example – so for example 10 to 100µH ferrite core high power inductor / choke in series and 220µF capacitor parallel after the inductor close to the servo). - 140 -