Download Manual

◆ Data and Firmware Upgrade
- 79
Make sure to follow the below directions when you use the machine.
 Miracle-A6 is designed to be operated DC24V. This machine is only to be
operated made when DC24V is available. When any
power supply other
than DC24V is used, the machine may not function properly In particular,
when low voltage (less than 24V) is used, the DC motor output decreases,
leading to slower rotation.
 Replace the Cutter on a regular maintenance basis. Delaying the
replacement of the Cutter may inhibit the cutting force, leading to failure of
accurate key cutting.
 Depending on the alloy makeup of the key blank, the necessary cutting force
of the Cutter should be adjusted. Set the cutting speed and cutting unit by
the strength of the key blank.
 Take precautions not to drop the machine or allow it to get wet (from rain or
snow) when using it outside.
 Make sure to check for errors on the key blank before cutting the key. An
error on key blank itself may produce unexpected results, even if the
machine cuts the key accurately.
 This machine is not equipped with a function to sense the Clamp contact to
the tools. Therefore, when key cutting, the Clamp may be damaged by the
tools, depending on the type of the key or the type of the Clamp selected.
Take precautions when operating the key and the Clamp. The manufacturers
or resellers are not responsible for Clamp damage during the key cutting
process.
MIRACLE-A6
-4-