Download Manual

1) Speed Setting
- You can assign the cutting speed based on density of key materials in four stages: Low-Normal-High-Maximum.
When you press the button, the cutting speed is changed in the following order.
 If you cut key materials with high density at high speed, the cutter may break off or
cutting may not be done properly.
 Make sure to assign proper speed based on the nature of material.
2) Auto Key Measurement
- You can measure thickness, center and length of the key for more accurate key cutting.
When you press the button, the measurement setting is changed in the following order.
1.
No Measure
4.
3.
2.
Key Height Measure
5.
Key Center
Key Length
Key Length and
Measure
Measure
Center Measure
No Measurement
Used in Laser Key Cutting. It automatically measures thickness of the key to
prevent Clamp damage and ensure cutting to accurate depth.
Used regardless of the reference point of the key. It automatically measures
center of the key (this function is used when there is an error in key materials).
MIRACLE-A6
- 68 -