Download CPM 68K System Guide
Transcript
2.1 Overview This section describes how to build a custom version of CP/M- 68K by combining your BIOS with the CCP and BDOS supplied by Digital Research to obtain a CP/M-68K operating system suitable for your specific hardware system. Section 5 describes how to create a BIOS. In this section, we assume that you have access to an already configured and executable CP/M-68K system. If you do not, you should first read Section 6, which discusses how you can make your first CP/M-68K system work. A CP/M-68K operating system is generated by using the linker, L068, to link together the system modules (CCP, BDOS, and BIOS) . Then the RELOC utility is used to bind the system to an absolute memory location. The resulting file is the configured operating system. It is named CPM.SYS. 2.2 Creating CPM.SYS The CCP and BDOS for CP/M-68K are distributed in a library file named CPMLIB. You must link your BIOS with CPMLIB using the following command: A>LO68 -R -UCPM -0 CPM.REL CPMLIB BIOS.0 where BIOS.0 is the compiled or assembled BIOS. This creates CPM.REL, which is a relocatable version of your system. The cold boot loader, however, can load only an absolute version of the system, so you must now create CPM.SYS, an absolute version of your system. If you want your system to reside at the top of memory, first find the size of the system with the following command: A>SIZE68 CPM.REL This gives you the total size of the system in both decimal and hex byte counts. Subtract this number from the highest memory address in your system and add one to get the highest possible address at which CPM.REL can be relocated. Assuming that the result is aaaaaa, type this command: A>RELOC -Baaaaaa CPH.REL CPK.SYS The result is the CPM.SYS file, relocated to load at memory address aaaaaa. If you want CPM.SYS to reside at some other memory address, such as immediately above the exception vector area, you can use RELOC to place the system at that address. 7