Download MPC852TADS Users Manual - Freescale Semiconductor
Transcript
FreescaleMPC852TADS Semiconductor, - User’sInc. Manual Functional Description Freescale Semiconductor, Inc... TABLE 4-20. BCSR4 Description PON DEF ATT. MIIRXEN. When active (high), the MII Fast Ethernet Device Davicom DM9161E connected to Port D is enabled. When negated (low) all device output signals are tri- stated. 0 R,W PORESET PORESETa. When active (high), PORESET is implemented on the MPC852TADS. When negated (low), the board is out of Power on Reset. 0 R,W ETHRST ETHRST. When active (low), the Ethernet Device Davicom DM9161E gets reset and being initialized to its Reset value. When inactive, the Ethernet Device is out of Reset. 1 R,W BIT MNEMONIC Function 5 MIIRXEN 6 7 8-31 Reserved Not Implemented - R,W a. Not implemented. 4•12 On board EPP/SPP Command ConverterA For host-controlled operation, a host computer controls the board via the BDM Debug Port. This configuration serves for extensive debugging using an on-host debugger. Host computer can be connected with the board directly via On board Serial command converter or via On board EPP converter. No needs external parts. EPP is an asynchronous, byte wide, bidirectional channel controlled by the host device. This interface provides the capability to send data from the host computer to the MPC852T at a high speed. The bus is a multiplexed address/data bus connected to a D-Type 25 pins Parallel connector called P20. Typically, EPP operates on a two-phase-bus cycle. First, an address is generated on the bus and is latched by Altera logic when the host generates an address strobe. The Altera logic uses this cycle for control. A separate Data strobe is generated to perform the actual data transfer. Cycles are terminated when the Busy signal is transferred from the Altera to the host computer. In the Altera logic there is a parallel to serial converter for write data and a serial to parallel converter for read data from the MPC. The signals used for EPP Mode transfer are described in detail in TABLE 4-21. "Parallel Host Port Connector’s Signal Description with EPP I/F" below . The signals used for Serial Command Converter Mode transfer are described in detail in TABLE 4-22. "Parallel Host Port Connector’s Signal Description with Serial Command A. For FUTURE Use 59 For More Information On This Product, Go to: www.freescale.com Release 1.0