Download C164CI - USBid
Transcript
System Reset C164CI Special Operation Modes Pins P0L.5 to P0L.2 (SMOD) select special operation modes of the C164CI during reset (see table below). Make sure to only select valid configurations in order to ensure proper operation of the C164CI. Definition of Special Modes for Reset Configuration P0.5-2 (P0L.5-2) Special Mode Notes 1 1 1 1 Normal Start Default configuration. Begin of execution as defined via pin EA. 1 1 1 0 CPU Host Mode (CHM) CPU programming mode for OTP memory. 1 1 0 1 Reserved Do not select this configuration! 1 1 0 0 Reserved Do not select this configuration! 1 0 1 1 Bootstrap Loader Load boot routine via ASC0. 1 0 1 0 Bootstrap Loader + CHM Serial OTP programming via ASC0 using the bootstrap loader. 1 0 0 1 Reserved Do not select this configuration! 1 0 0 0 Reserved Do not select this configuration! 0 1 1 1 External Host Mode (EHM) Programming mode for OTP memory via external host. Requires emulation mode. 0 1 1 0 Reserved Do not select this configuration! 0 1 0 1 Reserved Do not select this configuration! 0 1 0 0 Reserved Do not select this configuration! 0 0 X X Reserved Do not select this configuration! The on-chip Bootstrap Loader allows moving the start code into the internal RAM of the C164CI via the serial interface ASC0. The C164CI will remain in bootstrap loader mode until a hardware reset not selecting BSL mode or a software reset. Default: The C164CI starts fetching code from location 00’0000H, the bootstrap loader is off, no OTP programming modes are active. Semiconductor Group 20-10 Version 1.0, 11.97