Download C164CI - USBid

Transcript
System Reset
C164CI
Special Operation Modes
Pins P0L.5 to P0L.2 (SMOD) select special operation modes of the C164CI during reset (see table
below). Make sure to only select valid configurations in order to ensure proper operation of the
C164CI.
Definition of Special Modes for Reset Configuration
P0.5-2
(P0L.5-2)
Special Mode
Notes
1 1 1 1
Normal Start
Default configuration.
Begin of execution as defined via pin EA.
1 1 1 0
CPU Host Mode
(CHM)
CPU programming mode for OTP memory.
1 1 0 1
Reserved
Do not select this configuration!
1 1 0 0
Reserved
Do not select this configuration!
1 0 1 1
Bootstrap Loader
Load boot routine via ASC0.
1 0 1 0
Bootstrap Loader +
CHM
Serial OTP programming via ASC0 using the bootstrap
loader.
1 0 0 1
Reserved
Do not select this configuration!
1 0 0 0
Reserved
Do not select this configuration!
0 1 1 1
External Host Mode
(EHM)
Programming mode for OTP memory via external host.
Requires emulation mode.
0 1 1 0
Reserved
Do not select this configuration!
0 1 0 1
Reserved
Do not select this configuration!
0 1 0 0
Reserved
Do not select this configuration!
0 0 X X
Reserved
Do not select this configuration!
The on-chip Bootstrap Loader allows moving the start code into the internal RAM of the C164CI
via the serial interface ASC0. The C164CI will remain in bootstrap loader mode until a hardware
reset not selecting BSL mode or a software reset.
Default: The C164CI starts fetching code from location 00’0000H, the bootstrap loader is off, no
OTP programming modes are active.
Semiconductor Group
20-10
Version 1.0, 11.97