Download "user manual"
Transcript
Chapter 1 Installation/Wiring I/O 3 Wire SNK Control Non-Reversing Connection Example Internal Supply (SNK) Stop 01 02 Start 04 Internal Supply (SRC) 3 Wire SRC Control Reversing 11 P046 [Start Source 1] = 2, t062 [DigIn TermBlk 02] Stop = 49 and t063 [DigIn TermBlk 03] = 51 Start A momentary input will start the drive. A stop Direction input to I/O Terminal 01 will stop the drive as specified by P045 [Stop Mode]. I/O Terminal 03 determines direction. 3 Wire SNK Control Internal Supply (SNK) Reversing Stop External Supply (SRC) Stop 01 02 03 01 02 03 04 Start Direction +24V Common Each digital input draws 6 mA. 01 02 03 04 Start Direction Opto Output (1 & 2)(1) t069 [Opto Out1 Sel] determines Opto-Output 1 (I/O Terminal 17) operation. t072 [Opto Out2 Sel] determines Opto-Output 2 (I/O Terminal 18) operation. When using Opto-Output with an inductive load such as a relay, install a recovery diode parallel to the relay as shown, to prevent damage to the output. Analog Output(1) t088 [Analog Out Sel] determines analog output type and drive conditions. 0-10V, 1k Ω minimum 0-20 mA/4-20 mA, 525 Ω maximum Opto-Output 1 17 CR +24V 19 Common Each Opto-Output is rated 30V DC 50 mA (Non-inductive). t088 [Analog Out Sel] = 0 through 23 The Analog Output Select jumper must be set to match the analog output signal mode set in t088 [Analog Out Sel]. Common 14 + 16 (1) Feature is specific to PowerFlex 525 drives only. 44 Rockwell Automation Publication 520-UM001G-EN-E - September 2014