Download StratoLoggerCF

Transcript
Preflight Checklist
q Visually inspect all wiring and check that terminal screws are
tight and wires secured. Check that battery is secured and
battery clip is attached properly. Close and seal avionics bay.
q Prep rocket, install engine, do not install engine igniter.
q Make sure altimeter power switch is OFF.
q Put on safety glasses if you will be working with BP charges.
q Install ejection charges (don’t forget to load with black
powder!) and chute protection. Make sure all recovery
harness points are connected!
q Connect ejection charge leads to avionics bay’s ejection
charge terminals, making sure that wires do not short
together or short to anything else. Do not exchange drogue
and main charge wires!
q Have your rocket inspected by RSO if applicable, install
engine igniter, and place rocket on launch pad.
q Turn altimeter power switch ON. If you hear a repeating
error siren, turn altimeter OFF and do not launch until
problem is corrected. The altimeter’s settings will be
reported; confirm that the Preset Number and Main
Deployment Altitude are set properly. Last flight altitude
will then be reported, followed by battery voltage. Make
sure battery voltage is within your expectations.
q Next, ejection charge continuity will be annunciated by a
series of one, two, or three beeps. Do not launch if
continuity status is not as expected! Ejection charges are
“armed” at this point: Keep body parts clear!
q If continuity is being reported as expected, attach launch
system leads to engine igniter and launch!
45