Download StratoLoggerCF
Transcript
Preflight Checklist q Visually inspect all wiring and check that terminal screws are tight and wires secured. Check that battery is secured and battery clip is attached properly. Close and seal avionics bay. q Prep rocket, install engine, do not install engine igniter. q Make sure altimeter power switch is OFF. q Put on safety glasses if you will be working with BP charges. q Install ejection charges (don’t forget to load with black powder!) and chute protection. Make sure all recovery harness points are connected! q Connect ejection charge leads to avionics bay’s ejection charge terminals, making sure that wires do not short together or short to anything else. Do not exchange drogue and main charge wires! q Have your rocket inspected by RSO if applicable, install engine igniter, and place rocket on launch pad. q Turn altimeter power switch ON. If you hear a repeating error siren, turn altimeter OFF and do not launch until problem is corrected. The altimeter’s settings will be reported; confirm that the Preset Number and Main Deployment Altitude are set properly. Last flight altitude will then be reported, followed by battery voltage. Make sure battery voltage is within your expectations. q Next, ejection charge continuity will be annunciated by a series of one, two, or three beeps. Do not launch if continuity status is not as expected! Ejection charges are “armed” at this point: Keep body parts clear! q If continuity is being reported as expected, attach launch system leads to engine igniter and launch! 45