Download Axe-Fx Firmware Release Notes

Improved power amp screen grid and anode voltage dependence calculations. This
results in more “open” tone and improved dynamic response especially when the
virtual power amp is overdriven. This has necessitated changes to the default
Cathode Squish value for the some models. Existing presets will have the
Cathode Squish value updated automatically upon recall.
Added “65 Bassguy Bass” amp model. This is the bass channel of an AB165
Bassman. The existing “65 Bassguy” model has been renamed “65 Bassguy Nrml” to
indicate that it is the normal channel.
Added “Vibra-King Fat” amp model.
List menus now wrap at limits when using up or down Nav buttons for easier
access to parameters at the opposite end of the list.
Fixed Mr Z Hwy 66 model gain dropping if Drive set above 9.5.
Fixed wrong stage gain in Deluxe Verb amp model.
Fixed wrong triode plate voltage in 1987X models.
Fixed wrong B+ capacitor value in 1959SLP and Plexi 100W amp models.
Fixed wrong transformer matching value and wrong coupling capacitor value in
Citrus Terrier model.
Fixed various errors in the Suhr Badger models. Re-MIMIC’d models accordingly.
Note that these amps do not have Hi-Cut controls and the Hi-Cut control in the
model is therefore non-functional.
Fixed wrong Tone pot value in Ruckus model in Drive block.
Fixed Hold in Ping-Pong Delay not working properly. Note that this fix will
increase the level of the echoes in existing presets.
*******************************************************************************
17.02
Low Cut and High Cut have been extended to the Quad-Tap and Quad Tape types in
the Multidelay block. These parameters control highpass and lowpass filters
which filter the feedback from all the delay lines in contrast to the individual
bandpass filters on each delay line. This allows quick and easy creation of
bandlimited delays.
Added Drive parameter to Quad-Tap and Quad Tape types in Multidelay block.
The behavior of the Feedback parameters in the Quad-Tap and Quad Tape types in
the Multidelay block has been improved. The feedback is no longer constrained
to sum to 100%. Instead the total feedback is calculated and then normalized to
100% if the total exceeds 100%. This allows easier control of the feedback
values.
Fixed VU Meter in Cab block not working when two instances of the Cab block are
present.