Download 3 - Schneider Electric

Transcript
Metering functions
Frequency
Operation
This function gives the frequency value.
Frequency is measured via the following:
b based on U21 or V1, if only one phase-to-phase voltage is connected to the Sepam
b based on positive sequence voltage in other cases.
Frequency is not measured if:
b the voltage U21 (or V1) or positive sequence voltage Vd is less than 40 % of Un
b the frequency f is outside the measurment range.
The measurement of the frequency f' is calculated according to the same principle,
from V'd or U'21 or V'1
2
Readout
The measurements may be accessed via:
b the Sepam display via the
key
b the display of a PC with the SFT2841 software
b the communication link
b an analog converter with the MSA141 option.
Characteristics
Main channels
Rated frequency
Range
Resolution
Accuracy (2)
Display format
Refresh interval
50 Hz, 60 Hz
25 to 65 Hz
0.01 Hz (1)
±0.01 Hz
3 significant digits
1 second (typical)
Additional channels
Rated frequency fn
Range
Resolution (1)
Accuracy (2)
Display format
Refresh interval
(1) On SFT2841.
(2) At Unp, under reference conditions (IEC 60255-6).
36
50 Hz, 60 Hz
45 to 55 Hz (fn = 50 Hz)
55 to 65 Hz (fn = 60 Hz)
0.01 Hz
±0.05 Hz
3 significant digits
1 second (typical)
SEPED303001EN - 01/2013