Download Adept MV Controller User`s Guide
Transcript
Appendix C IEC Test Information IEC Test Information The Adept MV controller has passed the following IEC 1131 test conditions: • Voltage drops, normal service: Severity level PS2 • Relative Humidity: Severity level RH2 • ESD (Electrostatic Discharge): Severity level 4* *The Adept controller was tested at severity level 4 for ESD. In order to maintain compliance, Adept advises the use of proper EMC suppression techniques. All cables between the controller and peripheral equipment, including the power chassis in an Adept robot system, should be shielded and properly grounded at both termination points. Where the use of unshielded cables cannot be avoided, additional EMC suppression measures, such as the use of twisted pair, ferrite inductors, or band pass filters, should be employed. More information on input/output performance characteristics for applicable boards in the Adept controller is available on request from Adept. Please contact Customer Service for a copy. NOTE: Adept MV Controller User’s Guide, Rev. A 229
Related documents
V+ Language User`s Guide, Ver. 13.0
V+ Language User`s Guide, Ver. 12.1
VPC-1000 MANUAL [20090528]
AdeptOne-XL/AdeptThree-XL Robot Instruction Handbook
VPC-2000
User`s Manual
Adept SetNetGo Software Quick Start Guide
Adept Technology 300CR User's Manual
AdeptVision VME User`s Guide Version 11.0
AdeptVision User`s Guide
AdeptVision Reference Guide, Rev A
1779-6.5.3,Data Highway II PLC-2 Family Interface User Manual