Download DVS-25HA

DVS-25HA
HUMIDITY COMPENSATION USING HEATER 1
Heater 1 can be used to reduce humidity levels under certain conditions.
When the relative humidity is greater than the humidity set point, Heater 1
operates according to a timer cycle as long as Stage 2 fans are not running.
When the humidity drops to the humidity set point - 3%, Heater 1 turns off.
This feature is enabled by setting internal switch # 11 to ON. The alternative
to using this feature is to compensate the Stage 1 minimum speed (see
Ventilation Settings — only one of the two compensation methods can be
used). Note that if zoned heaters are used, both heaters 1 and 2 are used
to compensate humidity.
Heater 1 operates
according to timer settings
Heater 1 turns off
Heater 1
3%
Relative
Humidity
Set Point
Heater 1 operates according to timer settings as shown below:
TIME ON
ON
OFF
TIME OFF
54
DVS-25HA.rev.06
Relative
Humidity