Download SWD-Collect - OMEGA Engineering

CHAPTER 5 Setting up the Instrument Parser
Defining a Parser Name
Referring back to Figure 5.2 (see Page 45), a text box is located adjacent
to each destination. Here is where the name of the Parser is entered.
1.
When creating a new Parser, click in the text box to show the cursor,
and enter a name for it.
2.
When editing a Parser for an instrument that is currently open,
simply click on the Parser Name to highlight it.
3.
When editing an existing Parser for a closed instrument, click on
the arrow to the right of this box to reveal your list of Parsers, then
select the one to be changed.
Setting up the Parser
With a Parser Name highlighted in the [Instrument Parser Setup] dialog
box (see Figure 5.2, Page 45), click on the ‘Setup’ button located along
the bottom of the box. You will advance to the [Parser Setup] dialog
box, similar to the example shown in Figure 5.3.
Figure 5.3: Parser Setup dialog box
Note the name of the Parser will appear dimmed in the top box. The
name cannot be changed on this screen. The cursor will be flashing in
the Definition text box.
46