Download SP-3000 control System Instructions

SP-3000
Operation Manual
curve
curve. It’s a low speed decelerate start curve.
L22
Medium
speed
setting curve
run
12%; setting value more smaller, the steeper
curve. It’s an accelerate end curve.
L23
Medium
speed
setting curve
run
12%; setting value more smaller, the steeper
curve. It’s a medium speed decelerate start
curve.
L25
High speed run setting
curve
12%; setting value more smaller, the steeper
curve. It’s a high speed decelerate start
curve.
L26
Creep run setting curve
12%; setting value more smaller, the steeper
curve. It’s a creep decelerating end curve.
L28
Zero run setting curve
12%; setting value more smaller, the steeper
curve. It’s a zero speed decelerating starts &
end curve.
L36
ASR (P constant at high
speed)
40*
L37
ASR (I constant at high
speed)
0.1*
L38
ASR (P constant at low
speed)
40*
L39
ASR (I constant at low
speed)
0.1*
L42
(FF increase)
0
L49
Vibration increase
0.00
L50
Mechanical
integral time
0.1
L51
Mechanical vibration load
inertia
0.01
L52
Control mode selection
0; speed control
L54
Torque offset
0; simulated value
L55
Torque offset (timer start)
L56
Torque offset (timer end)
L57
Torque offset (limit)
L60
Torque offset (drive side
increase)
L61
Torque offset (brake side
increase)
L65
Imbalance
compensation
selection)
L66
Imbalance
load
compensation (operation
time)
vibration
load
(act
68