Download "user manual"

54
Installation/Mounting
the Dish
1 3/4"
DEPTH
(MINIMUM)
BRICK
J
Figure 37, Drilling Holes for Wall Anchors
7. Horizontally
level the mast with a bubble level or plumb line.
To horizontally level the mast, place the level, or plumb line, on the mast at an
perpendicular angle to the wall. If you are using a bubble level, move the bottom
of the mounting foot to center the bubble in the window of the level. If you are
using a plumb line, move the lower part of the foot until the plumb line aligns
parallel to the side of the mast. With a pencil, draw line from the center line of
the lower foot onto the wall. For a details on this procedure, see the leveling the
dish section of this manual.
8. Align the center mark of the mounting foot with the line drawn in the horizontal level procedure, With a pencil, mark the remaining three outside holes.
9.
Remove the mounting foot. Then, drill three 1/2" holes at the locations just
marked. These holes should be at least 1-3/4" deep (The depth of this hole
depends on the length of the machine screws).
10. With a brush or air, clean the dust from the holes.