1
Download Embedded Support Partner User Guide
Transcript
Chapter 4: Setting Up the ESP Environment Setting Up the System Parameters (Single System Manager Mode Only) The system parameters enable you to set up an alias name, select the system mode (full or SGM), and add the system to a group. Perform the following procedure to update the system parameters in single system manager mode: 1. Click on the Set Environment button. 2. Click on the System button. The interface displays the Update System Information window. (Refer to Figure 4-12.) Figure 4-12 Update System Information Window (Single System Manager) 3. Set the parameters. (Table 4-3 describes the parameters that are available.) 4. Click the Update button. 114
