1
Download Embedded Support Partner User Guide
Transcript
Chapter 4: Setting Up the ESP Environment Figure 4-15 shows the Add New Client window for an ESP 2.0 client. Figure 4-15 Add New Client Window for ESP 2.0 Client (System Group Manager Mode) 6. Set the parameters for the client. (Table 4-4 describes the parameters that are available.) 7. Click on the Add Client button. 8. Click on the Continue button. For ESP 3.0 clients, ESP immediately subscribes the system without waiting for additional verification. If ESP cannot establish a connection between systems, ESP displays a message that indicates this. For ESP 2.0 clients, you must also configure SGM clients from the client side. 118
