Download User Manual D

J. Windage and elevation adjustment
The vertical and horizontal adjustments for the weapon sight can be achieved by turning the
elevation and windage adjustment mechanisms (4,5). Each click equals to 1/4 inches at 100
yards. When reaching the maximum of rotation, do not use force.
K. Brightness adjustment
By rotation the “R” handle, you may adjust the reticle’s brightness. Adjustment could be easily
seen if you look through the weapon sight while adjustment.
L. IR illuminator
This infra-red(IR) illuminator greatly enhances the performance of your device when remaining
almost totally visible to the naked eye. Staying in the dark, switch on your night vision device. If
the visibility is low, you may use IR1000 to improve the situation.
IR1000 installation:
It can be mounted onto the Picatinny Rail. Follow below instructions:
1. Loosen the fixing nut of IR1000.
2. Install the IR1000 onto the Picatinny rail.
3. Tighten the fixing nut of IR1000 tightly.
The IR1000 is powered with one CR123A lithium battery. To install the battery, unscrew the
cap of the battery housing and insert the battery following the polarity indication marked on the
housing. Put the cap in place.
The IR1000 has a control panel with two buttons. To switch the IR illuminator on/off, press
“+”and “-” buttons simultaneously. You can see the green LED lit on the back side of IR1000
When the IR1000 is switched on. By pushing the buttions “+”and “-”, you may adjust the IR
brightness.
The IR beam is focusable to change the field of coverage. To change the beam width slightly,
turn the IR lens.
You may need adjust the focusing of the IR beam to change the field of coverage. Do it by
slightly rotating the IR lens. The windage and elevation screws help adjust the direction of the
IR beam from the IR1000 in order to focus on the scene observed of the viewfinder of your
NVD. Use the included Allen wrench to rotate the adjusting screws until the IR beam is
centered. Please remember the adjustment should be performed under night light conditions
only.