Download M68ICS08SOM User`s Manual

P&E
CHAPTER 1 – INTRODUCTION
1.2
Microcomputer
Systems, Inc.
ICS08 INTERFACE SOFTWARE PACKAGE
Windows-optimized software components, in this example collectively
referred to as the ICS08RK software, include:
•
WINIDE.EXE
—
•
CASM08Z.EXE
—
•
ICS08RKZ.EXE* —
In-circuit/stand-alone simulator software for the
MC68HC908RK2 MCU
•
PROG08SZ.EXE —
FLASH memory programming software
•
ICD08SZ.EXE
—
Integrated development environment (IDE)
software interface to the MC68HC908-based
hardware for editing and performing software or
in-circuit simulation
CASM08Z command-line cross-assembler
Limited, real-time, in-circuit debugging software
*If your package is for a different MCU part, substitute the name of your
part for RK.
Note: In this documentation, the part number ICS08Z will be understood to refer to
the In-Circuit Simulator component of the software package, while ICS08 will
refer to the entire software package.
1.2.1
Software Requirements
The ICS08 software requires this minimum hardware and software
configuration:
1.3
•
An IBM-compatible host computer running Windows 95, Windows 98
or Windows NT operating system
•
Approximately 5 MBytes of available random access memory (RAM)
and 5 MBytes of free disk space
•
A serial port for communications between the ICS board and the host
computer
ICS08 PACKAGE FEATURES
The ICS08 package is a low-cost development system that supports editing,
assembling, in-circuit simulation, in-circuit emulation, and FLASH memory
programming. Its features include:
•
•
•
1-2
Editing with WinIDE
Assembling with CASM08Z
FLASH memory programming with PROG08SZ
M68ICS08SOM/D