Download uClinux course - The Basics

LabTool – User’s Guide
Page 26
Status
area
Figure 24 Set Capture Device
It is possible to select between two different color schemes, light or dark, as illustrated in Figure 25
below.
Figure 25 Set Color Scheme
4.2 Setup – Prepare for Measurement
Before starting to capture signals, the planned measurement needs to be setup. First, the needed
signals shall be selected. In the toolbar, below the menus, there is an Add Signal button (see Figure
23). It is also possible to add an analyzer of digital signals via this dialog, like I2C, SPI and UART. Tick
the boxes for the signals to add. It is also possible to select add an analyzer. If more analyzers are
needed, press the Add Signal button again.
Figure 26 Add Signal Dialog
Due to hardware design in side LabTool, select the lower numbered digital inputs first. If only a few
signals are needed, start using from D0 and up to the needed number of signals. The lower the
number of signals used, the higher the sample rate can be.
Copyright 2013 © Embedded Artists AB