Download M87x User Manual

Figure A 8
Note: In order to be used for GOOSE publication, the Dataset must be defined under
System\LLN0 as shown in Figure A9.
Figure A 9
5.
The second step in publication is defining a GOOSE message, Figure A10. Up to eight
independent GOOSE publications may be defined for each device. Only one is
required for cross-triggering any number of other devices. System\LLN0\gcb01 is used
in this example. All default entries shown in Figure A10 should generally be used in
most cases, but the user must select the dataset defined in step 4, above, from the pulldown menu in the box Dataset Reference. Then the Configuration Revision must be
incremented to at least 1 (usually incremented automatically by the IED Configurator).
This Revision number must match the corresponding GOOSE subscription settings on
all the other inter-triggered IEDs on the network (see step 7, below).
ML0021
November 27, 2011
132
Copyright 2011 Bitronics, LLC