1
Download M87x User Manual
Transcript
Operating Temperature Relative Humidity Installation Category Pollution Degree Enclosure Protection Altitude Intended Use Connections Current (S10, S11, S12) Current (S13, S14, S15, S16, S17) Voltage (CE units) Voltage (non-CE) ML0021 Environmental -40C to 70C 0-95% non-condensing IC III (Distribution Level) Refer to definitions below. Pollution Degree 2 Refer to definitions below. IP20 to IEC60529:1989 Up to and including 2000m above sea level Indoor use; Indoor/Outdoor use when mounted in an appropriately rated protective enclosure to NEMA or IP protection classifications, as required for the installation. Physical Terminal block with 10-32 Studs for current inputs. Accepts #10-16 AWG (5.3-1.3mm2) wire Recommended Torque: 16 In-Lbs, 1.81 N-m Terminal block with 8-32 Screws for current inputs. Accepts #10-22 AWG (5.3-0.33mm2) wire Recommended Torque: 16 In-Lbs, 1.81 N-m Removable Terminal Block, accepts #22-12 AWG (0.35 to 3.3mm2) wire, or terminal lugs up to 0.250" (6.35mm) wide. Standard 0.200" (5.08mm) header socket accepts other standard terminal types. Precautions must be taken to prevent shorting of lugs at the terminal block. A minimum distance of 1/8" (3mm) is recommended between uninsulated lugs to maintain insulation requirements. Recommended Torque: 10 In-Lbs, 1.13 N-m Removable Terminal Block, accepts #22-12 AWG (0.35 to 3.3mm2) wire, or terminal lugs up to 0.325" (8.25mm) wide. Standard 0.200" (5.08mm) header socket accepts other standard terminal types. Precautions must be taken to prevent shorting of lugs at the terminal block. A minimum distance of 1/8" (3mm) is recommended between uninsulated lugs to maintain insulation requirements. Recommended Torque: 10 In-Lbs, 1.13 N-m Class I equipment to IEC61140: 1997 November 27, 2011 6 Copyright 2011 Bitronics, LLC
