Download CAR-14 - MICRO-AIDE

Transcript
C hapter 3 – S etup S etup P rocedure - S ite S pecific D ata O nly
D ata F low C ontrol
A few of the setup and operational commands can generate considerable amounts of displayed data.
If the user wishes to observe this data on the screen of a PC it may be helpful to temporarily pause the
data stream being sent by the Reporter. The Pause and Resume commands may be used to provide the
required data flow control.
To Pause the data being sent press the Ctrl and S keys simultaneously. The data flow will be stopped
indefinitely. To Resume data flow press the Ctrl and Q keys simultaneously. This technique can be used to
freeze the data at the PC.
Another useful command is the Abort command. At any time during a lengthy data dump the remaining
data can be ignored or aborted by pressing the Esc key. The user can then issue another command im‑
mediately after the Abort is executed rather than wait until the lengthy data dump is completed.
S etup P rocedure - S ite S pecific D ata O nly
The Setup Procedure described in this section will typically be used by maintainers and technicians. A
Restricted Access session will be used to modify a limited portion of the Setup Database. Only modi‑
fications to site-specific parameters will be described. It is assumed that the user has logged onto the
Reporter using the Restricted Password. The Main Menu should be displayed. Refer to the sample data
entitled “Main Menu” on page 13.
Each command will be identified by its name as listed in the menu where it resides. The single-letter code
that executes the command will be listed in parenthesis.
It is assumed that the Union Pacific-defined c14sear2.v100 Setup Database has been installed in the
CAR‑14. The comm port of the PC must be set to operate at a speed of 9600 Baud.
Before proceeding with the Setup Procedure, verify that the front panel LED labeled “Maintainer Mode”
is illuminated. If it is not, press the switch labeled“Maintainer Mode PB” for .5 seconds. The Maintainer
Mode LED should now be illuminated confirming that the CAR‑14 is operating in Maintainer Mode. This
will prevent any Alarms from being sent while the Reporter is being set up.
3
S ite S pecific I nformation (F)
Site parameters are grouped within a single Main Menu command. To change any of the settings, start
by selecting the Site Specific Information command. A collection of fields with data similar to the follow‑
ing will be displayed.
Site Specific Information
------------------------State
XX
Subdivision
0000
DOT number
TESTXXX
Time Zone
CST (UTC-6)
Daylight Saving Time Enabled
DNS Name
m402555TEST.airlink.uprr.com
Analog Configuration
Low Limit High Limit
--------- ---------10.4
15.6
11.2
16.8
0.0
20.0
0.0
20.0
Input
----A01
A02
A03
A04
Site Specific Information Command
The name of each field is listed to the left of each setting. Fields can be modified or skipped as required.
A description of each field is provided in the following sections.
M icro ‑A ide
15