Download User Manual

4. Troubleshooting
Log Messages
Table 4-5 LPFC Error Log Messages and their Descriptions (Continued)
1053: Start Authentication: Security service offline
The authentication failed because security service was unavailable.
Data:
None
Severity: Error
Log:
LOG_SECURITY
Action: Software driver Error. If this issue persists, report errors to the Technical Support.
1055: Authentication parameter is disabled, but is required by the fabric
FLOGI failed because the fabric has indicated that authentication is required, but authentication has
not yet been configured or enabled on the HBA.
Data:
None
Severity: Error
Log:
LOG_SECURITY
Action: Configure authentication on this HBA.
1057: Authentication transaction reject. reason <reason> exp <explanation>
An authentication was rejected and requested again due to the reason as displayed with the
explanation.
Data:
(1) reason (2) explanation.
Severity: Error
Log:
LOG_SECURITY
Action: Software driver Error. If this issue persists, report errors to the Technical Support.
1058: Waiting for authentication service
There was
Data:
Severity:
Log:
Action:
a delay when the authentication service was not initially available as expected.
None
Warning
LOG_SECURITY
Software driver warning. If this issue persists, report these errors to Technical Support.
1059: Authentication became available
The authentication service came online but was not initially available as expected.
Data:
None
Severity: Warning
Log:
LOG_SECURITY
Action: Software driver warning. If this issue persists, report these errors to Technical Support.
1201: Failed to allocate dfc_host
Failed to allocate memory for the dfc_host_struct.
Data:
None
Severity: Error
Log:
LOG_ELS
Action: None required.
1210: Invalid cmd size: cmd <cmd> cmdsz <cmdsize> rspsz <rspsize>
The management command for LPFC 2100 has failed.
Data:
None
Severity: Error
Log:
LOG_LIBDFC
Action: None required.
Emulex Drivers Version 10.4 for Linux User Manual
P011043-01A Rev. A
141