Download User Manual

4. Troubleshooting
Log Messages
Table 4-6 Ethernet Driver Log Messages of Type (Continued)
Ethernet Log Message
Description
Type
Adapter recovery failed
Adapter error recovery failed.
Error
(Only if reported by the LPe16000-series adapters.)
Adapter recovery succeeded
Adapter has successfully recovered after an error.
Information
(Only if reported by the LPe16000-series adapters.)
Cannot set rx filter flags
<XX>
Interface is capable of <XX>
flags only
Failed to change RX filter settings on an interface
as requested, as interface does not have the
capability.
Can't load BE3 UFI on BE3R
The UFI image can only be flashed on the OCx111xx Information
chip but not on the OCx111xxR chip.
Could not create sysfs group The creation of the “flash_fw” entry under the
/sys/class/net/eth<x> failed. The driver is fully
functional but you cannot install later firmware
versions on the adapter.
Warning
Error
Could not enable VLAN
Promiscuous mode
Firmware command failed to enable VLAN
promiscuous mode.
Error
Could not enable Wake-on-lan
Enabling Wake-on-LAN on the adapter failed.
Error
Could not get CRC for the
<DD> region
The driver could not get enough information from Error
the adapter to decide whether a region from a
firmware image should be flashed. The driver skips
updating this section. This is a very unlikely error.
Could not get <DD> MSI-x
vector(s)
Using <DD> vector(s)
Enabled only a subset of MSI-x vector(s) requested. Information
Could not set PCI DMA Mask
The operating system call to set the DMA mask
failed.
Error
created <DD> RSS queue(s) and This is an information message reporting how many Information
1 default RX queue
receive rings with RSS capability were created. In
addition, a default receive ring is created to
receive non-IP traffic.
created <DD> TX queue(s)
Information
An informational message logging number of
transmit rings created.
<DD> VFs are already enabled When unloading the driver while a VF is still
assigned to VM, the VFs remain enabled. When the
driver is re-loaded, this message is logged the
number of VFs that are enabled and active.
Emulex Drivers Version 10.4 for Linux User Manual
Information
P011043-01A Rev. A
174