Download NetModule Router NB3700 - S
Transcript
NB3700 User Manual Administration This page can be used to enable/disable IPsec, you may also specify whether NATTraversal should be used. NAT-Traversal is mainly used for connections which traverse a path where a router modifies the IP address/port of packets. It encapsulates packets in UDP and therefore requires a slight overhead which has to be taken into account when running over smallsized MTU interfaces. Please note that running NAT-Traversal makes IKE using UDP port 4500 rather than 500 which has to be taken into account when setting up firewall rules. Figure 5.28.: IPsec Configuration General For setting up the tunnel you will have to configure the following parameters first: Remote peer: IP address or host name of the remote IPsec peer (aka responder or server) DPD Status: Specifies whether Dead Peer Detection (see RFC 3706) shall be used. DPD will detect any broken IPSec connections, in particular the ISAKMP tunnel, and refresh the corresponding SAs (Security Associations) and SPIs (Security 69