Download DPX 4 / Fredia User Guide
Transcript
DPX 4 User Guide Chapter 9 – Troubleshooting ERRORS Message Processor Fail, Act temp sensor error Remarks An error is reported when any of the following conditions are detected: • The activator temperature read less than 0.5 Deg. C (Hardware fault) • The temperature was greater than 43 Deg. C (Overlimit) • The temperature exceeded the setpoint by more than 3 degrees (FW control loop failed) Processor Fail, Stab temp sensor error The stabilizer temperature read less than 0.5 Deg. C (Hardware fault) Processor Fail, Dryer temp sensor error The dryer temperature read less than 0.5 Deg. C (Hardware fault) Processor Fail, Eco Hardware Interface error The low level driver failed to initialize resulting error codes range from 2320 through 2324 Processor Error, Interlock The processor interlock has been detected resulting error code 1901 Processor Error, Activator Level Low The activator tank AND the activator replenish tank are both low resulting error code 2001 Processor Error, Stabilizer Level Low The stabilizer tank AND the stabilizer replenish tank are both low resulting error code 2003 Processor Busy, Waste container full The waste tank is full and must be emptied Processor Error, Water Level Low The water supply tank is empty 55