Download V29t

RULES FOR SAFE OPERATION
READ ALL INSTRUCTIONS BEFORE OPERATING
AUDIO AND VIDEO SAFETY WARNINGS:
• Mobile DVD Player is a class I laser product. However this
mobile DVD player uses a visible/invisible laser beam which
could cause hazardous radiation exposure if directed.
• Be sure to operate the mobile DVD player correctly as
instructed.
• Do not open covers and - DO NOT repair yourself. Refer
servicing to qualified personnel.
• To reduce the risk of fire or electric shock, DO NOT expose this
equipment to rain or moisture.
• This device is intended for continuous operation.
• Read the instructions carefully. Be familiar with the controls and
proper use of the unit.
• Children must not use the unit, except teens guided by an adult.
• Do not place head over top of unit when ejecting Golf Club – Be
aware of the risk of injury to head or face.
• Always make sure area around bag is clear when ejecting a golf
club.
• High wind may carry golf club when ejected from unit.
ELECTRICAL SAFETY WARNINGS
OTHER SAFETY WARNINGS:
DANGER! RISK OF ELECTRICAL AND FIRE HAZARD. MAY
RESULT IN DEATH, SERIOUS INJURY, SHOCK OR BURNS.
• Store the unit in a dry place.
• Store the unit in an upright position.
• Secure the unit properly on any golf cart – follow ALL
instructions.
• Use caution when lifting the unit.
• Keep these instructions. Refer to them often and use them to
instruct other users.
• Save these instructions.
TO HELP REDUCE THIS RISK:
• Unit is an electrical device - care must be taken when charging the
battery. Follow all battery charging instructions.
• DO NOT short-circuit or disassemble the battery. A short-circuit may
cause severe damage to the battery.
• DO NOT drop, hit or otherwise abuse the battery. This behavior may
result in the exposure of the cell contents, which are corrosive.
FCC SAFETY NOTICE:
• DO NOT expose the battery to moisture or rain. Keep battery away
from fire or from other sources of extreme heat. Do not incinerate.
• This device complies with Part 15 of the FCC Rules.
Exposure of battery to extreme heat may result in an explosion.
•
Operation of this device is subject to the following two
• DO NOT disassemble charger. Take it to a qualified service person
conditions:
when service or repair is required. Incorrect reassembly may result
• This device may not cause harmful interference, and
in a risk of electric shock or fire.
• this device must accept any interference received, including
• DO NOT expose charger to rain, snow, water, gas, oil, etc.
interference that may cause undesired operation.
• DO NOT operate charger if it has received a sharp blow, been
• This equipment has been tested and found to comply with the
dropped, or otherwise damaged in any way; take it to a qualified
limits for a Class B digital device, pursuant to Part 15 of the FCC
service person.
Rules. These limits are designed to provide reasonable
• DO NOT block air holes in top or bottom of charger.
protection against harmful interference in a residential
• Charger MUST be grounded to reduce risk of electric shock.
installation. This equipment generates, uses and can radiate
• The plug MUST be plugged into an outlet that is properly installed
radio frequency energy and, if not installed and used in
and GROUNDED in accordance with all local codes and ordinances.
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
• This equipment has been certified to comply with the limits for a
Class B computing device, pursuant to FCC Rules. In order to
maintain compliance with FCC regulations, shielded cables must
be used with this equipment. Operation with non-approved
equipment or unshielded cables is likely to result in
interference to radio and TV reception. The user is cautioned
that changes and modifications made to the equipment without
the approval of manufacturer could void the user’s authority to
operate this equipment.
2