Download MFB for Modicon M340 using Unity Pro

Transcript
Maintenance
Replacing a Faulty Servodrive
At a Glance
If the servodrive fails, it may be necessary to swap it for an identical servodrive
(reference). To do this, you are advised to save the adjustment parameters to a data
table using the TE_UPLOADDRIVEPARAMETER (see Unity Pro, Motion Function
Blocks, Block Library) block.
The TE_DOWNLOADDRIVEPARAM (see page 60) block then allows you to restore
the saved data to a new servodrive.
Data Backup
The table below describes the procedure used to back up the servodrive’s data
using the TE_UPLOADDRIVEPARAMETER (see Unity Pro, Motion Function
Blocks, Block Library) block:
Step
76
Action
1
Disable the Enable parameter, which belongs to the MC_POWER (see Unity Pro,
Motion Function Blocks, Block Library) block.
Result: the servodrive switches to Disable (see Unity Pro, Motion Function Blocks,
Block Library) mode.
2
Enable the input parameter Execute.
Result: the servodrive switches to Downloading (see Unity Pro, Motion Function
Blocks, Block Library) mode.
The data table assigned to the output parameter PARAMETERSET is filled in.
Note: Please back up data to a .DAT file using PLC →Transfer PLC data to the
file if the PLC has no memory card.
35013563 05/2010