Download AUDIO PRECISION System One Users

ERROR MESSAGES
1 : Select or use only DSP programs supplied by
Audio Precision with the .DSP extension. To date
all DSP programs released are compatible with the
2.10A release of S1.EXE.
33-17
CORRECTIONS : Select generator amplitude
(GENAMP) as a sweep SOURCE-2 parameter only.
GENFREQ may only be a sweep source-2 selection
2 : Select the appropriate version DSP programs
to be run with the selected S1.EXE software or visaversa.
NOTE : Error generated by the FFTGEN DSP
program.
NOTE : Refer to the technical bulletins issued
with each update.
CAUSES : Caused by trying to select GENFREQ
as sweep SOURCE-1.
FILE WRITE ACCESS DENIED — DIRECTORY FULL OR WRITE PROTECTED
CORRECTIONS : Select generator frequency
(GENFREQ) as a sweep SOURCE-2 parameter only.
CAUSES : The selected file cannot be written to
a storage medium because the file attribute is set to
READ ONLY, the storage medium does not have
room to store the file, or the disk is write protected.
Generator waveform frequencies too close for
triggering or frequency correction
CORRECTIONS : Clear the READ ONLY file
attribute using the DOS ATTRIB command, create
room for the desired file, or remove the write protection from the storage medium.
NOTE : Error generated by the FASTTRIG DSP
program.
CAUSES : An attempt to execute a test with a
DSP generator waveform loaded that has tones that
violate the minimum frequency spacing of six bins
(about 35 Hz with maximum resolution signal).
FREQRS may only be a sweep source-2 selection
CORRECTIONS :
NOTE : Error generated by the FASTTEST and
FASTTRIG DSP programs.
CAUSES : Attempting to select the frequency
resolution (FREQRS) as a sweep SOURCE-1 stimulus.
CORRECTIONS : Select frequency resolution
(FREQRS) as a sweep SOURCE-2 parameter only.
G
GENAMP may only be a sweep source-2 selection
NOTE : Error generated by the FFTGEN, MLS,
FASTTEST and FASTTRIG DSP programs.
CAUSES : Attempting to set the generator amplitude (GENAMP) parameter as the sweep SOURCE1 selection on the sweep definitions panel.
1 : Change to a waveform which conforms to the
minimum spacing criteria.
2 : Disable generator waveform & frequency correction warnings by setting the MEASURE right
hand field to OFF on the FASTTRIG DSP panel.
GOTO CANNOT FIND TARGET LABEL
CAUSES : The procedure currently being run
can’t find the label designated by the GOTO command.
CORRECTIONS : Check to see that the label exists in the same procedure as the GOTO statement
and that the characters in the label are the same as
designated by the GOTO statement.
H