Download G1047 - Neoptix

Transcript
Auto-tune CCD
Analog output zero
Analog output span
Analog output, if no
probes
Optimize the CCD operation, especially useful when working
with “weak” or “marginal” probes. Has the advantage also to
lower the voltage on the internal lamps, thus improve long-term
system reliability.
Adjust the analog output zero setting, for each channel.
Warning: this command must be sent individually for each
channel.
Adjust the analog output span setting, for each channel.
Warning: this command must be sent individually for each
channel.
Adjust the analog output behavior, when no probe is detected.
Warning: this command must be sent individually for each
channel.
wtune+
z1 -50
z2 –50, etc.
s1 200
s2 200, etc.
See “o” command
description, above
Most of these command settings can be confirmed with the “i” command. The “wtune” command can be
confirmed with the “y” command.
5.5.2 Interpretation of “y” command results
The Neoptix T/Guard systems are fitted with a function that gives an evaluation about probe signal strength
or signal power; in Neoptix jargon, this is called the “y” command. The easiest method to access this
command is to use Windows’ HyperTerminal, or OptiLink’ Console; the Nomad, when in Engineering mode,
can also be very useful to display this information.
Typically, the “y” command will return the following information:
CH1: 85%, ratio:1.83, lamp:90, CCD:150ms (auto) +24.5
CH1 indicates the channel number (typically 1 to 16, for a 16-channel T/Guard system)
1.83 is a signal strength (power) indicator that can span from about +0.3 to +2.7. You can interpret it
approximately as follows:
• 0.3 to 1.07: no probe is detected
• 1.07 to 1.25: a probe is probably present, but exhibits a very weak signal; its reading is usually
rejected, as it is considered as unreliable
• 1.25 to 2.7: a good probe is present (the higher the power the more healthy the probe).
Lamp attenuation: gives an indication about the white light lamp intensity for this channel. It ranges from 210
(weak lamp) to 100 (intense lamp). A weak lamp is usually preferred and indicates a “healthy” probe.
CCD time: this is the CCD (charge couple device) optical integration time in millisecond; it can range from 50
to 500 ms. A weak probe will normally have a long integration time.
The “%” number gives an approximate compounded power value that takes into consideration the ratio, the
lamp attenuation and the CCD time.
The “auto” information indicates that the “wtune” feature is enabled.
To summarize, a very good probe is characterized by a good power indicator (>1.8), then by a high lamp
attenuation (>150) and finally by a short integration time (<200ms). Also, dirty connectors will contribute to
lower probe strength; always assure that all fiber connections are clean before evaluating probe performance.
Warning: After a power-on or after changing (or exchanging) probes or extension cords, allow sufficient time
for the T/Guard optimization process to complete before invoking the y command; it most cases, it may take
as much as 1 minute for this optimization to complete, especially when the number of enabled channels is
high, e.g., 8.
5.6 Typical temperature reading sequence
Once all parameters have been set, the following sequence should normally be followed to extract
temperature information from your Neoptix thermometer. 2 procedures can be used for this purpose. The first
method consists in using the “ta” command (preferred), while the second sequence would be:
Document no. G1047r03
Copyright Neoptix Canada LP
22