Download G1047 - Neoptix

Transcript
8.5.2 Writing parameters
To write data, you must select either Holding Register, or Coil Status. Then, from the main menu bar, select
Setup, then Extended, then Preset Regs. Make sure the value of “Number of Points” is 1 (you cannot write to
multiple registers at once). Make sure the Slave Device is corrected set (node number), and that the Address
points to the register address you want to modify. For example, to change a temperature value, say from 200
to 150, you will enter (remember to multiply the temperature value by 10):
Click update to “write” your new value.
8.5.3 Data logging
ModScan allows you to log either in a text file (.txt) or a database file (.mdb, Microsoft Access format). Both
are similar. Here is a quick example, saving to a text file.
Select Setup from the main menu, and then Text Capture. In the Save As box, enter a proper file name (if
using Windows Vista or Windows 7, make sure your file is not saved in the Program File directory). In the
next window, enter the frequency at which you want to log data:
Data logging will automatically start. To end logging, select Setup and then Capture Off. The saved file can
then be open using WordPad (do not use Notepad). Typically, the saved data should look like this:
It is then easy to read this file as an Excel file.
Warning: If you have multiple ModScan windows open, you must start multiple logging sessions.
Document no. G1047r03
Copyright Neoptix Canada LP
50