1
Download JTec J5000 Reference Manual - Industry Surplus Australia
Transcript
4-140 Analog Line Exchange Module-2 (ALEM-2) ISDN Interface — High Layer Compatibility The setting for these parameters should be left as defaults. However, changes can be made to them to accept different services from a single line. CCITT (ITU-T) Standards Telstra Standards (Australia only) Parameter Default Incoming Telephony and Group 2/3 Facsimile Outgoing None Incoming Group 1 - 3 Facsimile Outgoing None Changing High Layer Compatibility defaults It is not usual to change the High Layer Compatibility settings for an ALEM-2 line. However, you can change them to accept different services from a single line. See Parameters page 2-10 for a full description of the available parameters. ISDN Interface — Call Establishment Modes Parameter Default Enable Disabled Label — Enable Disabled Number — XSPC Disabled Subaddress — Auto Answer Disabled Release on Progress Disabled Tone Suppress Disabled National Significant Remote Number — End-to-End Disabled Interpreted Disabled Unack Disabled Semipermanent (where available) Hotline Call Control Line facilities Signalling Changing Call Establishment Modes defaults Semipermanent (where available) Select Enable and enter the semipermanent label to set up a semipermanent connection from an ALEM-2 line. You should also disable Hotline calls. Note The semipermanent label is supplied by your service provider. 10003497.00 Rev.5
