Download D400 Substation Data Manager

GE Energy
Setting
Supported
Command
Description
Command the DNP3 server should expect. If the
DNP3 server receives a command that is not
configured, it will reject the command.
Range
All operations
SBO Only
Default
User selected
Default
Settings are available in the lower pane of the Digital Outputs tab. The configuration
settings defined in Table 102 are used to configure the default values for all digital
output points defined in the DNP3 server map.
Table 102 Digital Output Properties
Setting
Default
Command
Supported
Description
The DNP3 server uses this as the default
command to support, when the master does
not request any specific type.
Range
All operations
SBO Only
Default
SBO Only
Accumulators
The accumulators are used for reporting running values, frozen values, and events.
This means that the same DNP3 point index is used for both the running and frozen
value. The DNP3 server returns the running value when data points for Static
Variation (Object 20) is requested by the master station. The DNP3 server returns the
frozen value when data points for Static Variation (Object 21) is requested by the
Master station. The Threshold configured is used to qualify events for running
accumulators only Event Variation (Object22). Frozen accumulator events (Object 23)
are generated whenever a configured accumulator is frozen.
Settings are available on the Accumulators tab. The default property values are
defined in the lower pane. The D400 provides the mapping settings for accumulators
(counters) as shown in Table 103.
Table 103 Accumulator Mapping Settings
Setting
114
Description
Range
Default
Index
Point Index (0 Based). Each point index number
must be unique.
0 to 65535
Incremented
from 0.
IED
System Point Identifier. Consists of Home
Directory and Point Name. Based on selected
ACC point from the Point Picker. Read only.
N/A
System
Assigned
Identifier
Point Name
Text description of the point in the Accumulator
map. Based on selected ACC point. Read only.
Up to 128
characters
Assigned IED
point name.
Threshold
Minimum change required in the Running
Accumulator count to cause an event to be
generated. 0 will disable generation of Running
Accumulator Events.
0 to 5000
User selected
Default
Static Variation
How the point values should be reported.
Applies to Running value.
32-Bit
16-Bit
User selected
Default
SWM0066–2.75–0, General