Download D400 Substation Data Manager

GE Energy
8.2
Setting up a Terminal Session
You can access these system utilities directly at the D400 command prompt through
the local maintenance port or remotely through the Utilities Power bar button in the
D400 HMI. The Utilities page provides a TELNET or a Secure Shell (SSH) login to
establish a remote terminal session with the D400.
Access to the command line interface requires an Administrator or root log in.
Note: When accessing the D400 with an Administrator-level user account, you may
not have sufficient security privileges to execute the commands listed in this manual.
If this occurs, type “sudo “ in front of each command.
Refer to the D400 Substation Data Manager User’s Manual (994-0089) for instructions
on how to access the D400’s command line interface.
8.3
D400 Configuration Utility
The D400 Configuration Utility is used to configure operating system (Linux) specific
settings on the D400. Using the D400 Configuration Utility, you can perform the
following actions:
•
Control user authentication mode
•
Configure network and network interface settings
•
Configure secure access
•
Configure host names
•
Configure time synchronization
•
Reset system logs
•
Reset mSQL database tables
•
Reset NVRAM
• Configure KVM monitor settings
The D400 Configuration Utility differs from the D400 Configuration Tool in the D400
HMI in that it directly modifies Linux system configuration files rather than generating
XML configuration files.
D400 Substation Data Manager Software Configuration Guide
171