Download ESP-SMT Smart Modular Control System

Transcript
Remote Panel Programming

Installing a 9-Volt alkaline battery in the ESP-SMT Smart
Modular controller will allow you to program the controller
panel while disconnected from the cabinet.
The battery is NOT required to maintain program
information. After you pre-program the ESP-SMT
controller, remove the 9-Volt battery. The programmed
information will then be saved in non-volatile memory.
Open the cabinet door and then open the front panel
A
by grasping the crescent shaped finger hold on the
top right side of the cabinet. Swing the face panel to
the left.
B
This device complies with Part 15 of the FCC Rules.
Operation is subjected to the following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference received,
Locate the battery compartment on the rear of the
B
including interference that may cause undesired operation.
Canadian Interference Causing Equipment Regulations.
front panel.
Install the new battery and slide it into the
C
compartment. Then close the front panel.
The controller panel may now be disconnected from the
housing in order to operate remotely. Refer to previous
chapter “Mounting the Controller” for instructions on how
to disconnect the controller panel.
LAWN SPRINKLER CONTROL
-DOMESTICINPUT: 120 VAC, 0.3 AMPS, 60Hz
OUTPUT: 25.5 VAC, 1.0 AMPS, 60Hz
This class B digital apparatus meets all requirements of the
Cet appariel Numérique de la classe B respecte toutes les
exigences du Règlement sur le matériel brouilleur du Canada.
SMX SENSOR
C
WARNING
RISK OF FIRE, EXPLOSION AND ELECTRICAL SHOCK.
THIS CONTROLLER USES A NON-REPLACEABLE LITHIUM
BATTERY. DISPOSE OF ALL ELECTRONIC PRODUCTS IN
ACCORDANCE WITH LOCAL LAWS AND FEDERAL REGULATIONS.
ACCESSORY
RESET
IF DISPLAY IS SCRAMBLED
OR BLANK, PUSH THE
RESET BUTTON
!!
NOTE: With a battery installed and the front panel
disconnected from the cabinet, you can program all
zone information and it will be immediately saved
in nonvolatile memory. However, once AC is applied,
information entered for a non-existent module will be
erased.
ESP-SMT Smart Modular Control System
64