Download microsKanner User Manual

Screen
I
SPRT
I
V
V
The top terminal should be connected to the screen of the SPRT’s lead (where
present) to minimise electrical noise picked up by the wires.
3.3 Connecting PRTs (3-wire)
The microsKanner and microK can be connected to 3-wire PRTs, although they
will not automatically compensate for cable resistance. The two red terminals
should be connected together and then connected to the ‘single’ end of the 3-wire
PRT as follows:
Screen
I
I
V
V
The connection to the ‘single’ end of the 3-wire PRT should be short (have a low
resistance) in order to minimise the effect of lead resistance on the measurement.
The top terminal should be connected to the screen of the PRT’s lead (where
present) to minimise electrical noise picked up by the wires.
©
Page 17 of 48
Issue: 1.01