Download User Manual

Advanced Operation
RS-232 / IP Commands
#set_http_port
The #set_http_port command specifies the Web server listening port. The matrix must
be rebooted after executing this command. The default port setting is 80. The current
HTTP listening port can be displayed using the #show_http_port command.
Syntax:
#set_http_port param1
Parameters:
param1
Port[1 ... 1024]
Example:
#set_http_port 82
HTTP Communication Port 82 Is Set. Please Reboot The Unit.
#set_telnet_pass
The #set_telnet_pass command sets the Telnet password. The password cannot
exceed 20 characters in length. The matrix must be rebooted after executing this
command. The default password is Admin.
Syntax:
#set_telnet_pass param1
Parameters:
param1
Password
Example:
#set_telnet_pass reindeer
TELNET Interface Password Is Set.
page | 33