Download PC Tool CU 3

Transcript
Description of all the
connection
possibilities
The table below describes the different connections shown in fig. 1.
Note: The PC Tool CU 3 kit does not include modems, radios, bus cable or D-sub
connectors. Nor does Grundfos supply these parts. To make a direct GENIbus connection to a CU3/SM100 network from a PC you need to order the special Grundfos
PC Tool Link adapter. To communicate via GENIbus each CU3 device needs a RS485 plug-in module board of which one is included with the tool kit. Additional modules can be ordered.
Connection
1. Direct connection
2.a G100 Service port
direct
2.b G100 Service port
via modem
3.a G100 R/M/P direct
Description
Direct connection to GENIbus.
The G100 service port (RS-232) can be
used to connect direct to a PC COM
port.
The G100 service port (RS-232) can be
used to connect to a PC COM port via
modem.
Direct connection via G100 to a network
of up to 32 CU 3 units.
3.b G100 R/M/P via
modem
Modem connection via G100 to a network of up to 32 CU 3 units.
3.c G100 R/M/P via
radio
Radio connection via G100 to a network
of up to 32 CU 3 units.
Requirements
• 1 Grundfos PC Tool Link adapter.
• Twisted pair bus cable with shield.
• The RS-232 null-modem supplied
with the tool can be used.
•
•
•
•
•
•
•
•
•
•
•
•
1 G100.
2 modems.
2 modem cables.
Twisted pair bus cable with shield.
1 Sub-D, 9-pin connector to G100.
1 G100
The RS-232 null-modem supplied
with the tool.
1 G100 R/M/P version.
2 modems.
2 modem cables.
Twisted pair bus cable with shield.
1 Sub-D, 9 pin connector to G100.
• 1 G100 R/M/P version.
• 2 radios.
• 2 RS-232 cables to radio.
• Twisted pair bus cable with shield.
• 1 Sub-D, 9 pin connector to G100.
List of products
Product
Product No.
G100 R/M/P
RS-485 plug-in Module Board for CU 3
96 41 11 36
62 61 59
Grundfos PC Tool Link adapter
96 47 20 84
5