Download Positioning ACU

Transcript
3.5.1.3
No motor encoder, external encoder for positioning
In some applications the speed control accuracy and the dynamic behaviour of a
sensorless motor control are sufficient. Positioning is possible in non-slip and in slipcontaining systems via an external encoder.
Configuration 30 = 440, only position encoder
Encoder 1
Encoder 2
Motorregler
Position controller
Operation mode
Operation mode
490
493
Actual Speed
Source 766 = 3 -
Actual Position
Source 1141 =
Machine Model
Division Marks
Division Marks
491
494
"1 - Speed Sensor 1"
or "2 - Speed Sensor
2", depending on
the application
Level 495
Set the encoder behaviour in the correlative parameters for speed sensor 1 and
speed sensor 2. The speed sensor 1 parameters are only available if an expansion
module with speed sensor input is installed.
3.5.1.4
Consider the operation mode settings for speed sensor input
The digital input signals S4IND, S5IND and S6IND can set as signal sources in all
configurations (parameter Configuration 30).
− In parameter settings Operation Mode 490 > 0 the inputs S4IND and S5IND are
evaluated only as speed sensor inputs. Other functions at these inputs are not
evaluated.
− In parameter settings Operation Mode 490 > 1000 additional the input S6IND is
evaluated as speed sensor track. Other functions at this input are not evaluated.
Digital
inputs
S4IND
S5IND
S6IND
20
Operation Mode 490 =
1001 … 1132
1 … 1000
0
Speed sensor 1 track B
Free programmable
Speed sensor 1 track A
Free programmable
Speed sensor 1 track Z
Home switch
Application manual Positioning
04/08