Download 3710 Portable Samplers

3710 Portable Samplers
Section 3 Programming Guidelines
For information on the reports produced by the Field Printer,
refer to the Field Printer Instruction Manual.
When you select “PRINT,” Display #149 appears. Use this display
to select the settings or results report. (The sampler will
interrupt the reports to take a sample, if necessary.) Select “NO”
to return to standby.
PRINT PROGRAM [NO,
SETTINGS, RESULTS]
Display #
149
The sampler will display one of two messages as it sends the data
to the printer. The first message informs you that the transmission is in progress. The second message is a warning which
informs you that the sampler is unable to detect the printer. If
you see the warning message, check the cable connections
between the printer and the sampler.
. . . PRINTING . . .
PROGRAM INFORMATION
PRINT ABORTED
NO PRINTER DETECTED!
3.14.5 Source of Sample
Event
The display illustrated in step 5 of Example Reviewing the Sampling Results, on page 3-59, shows the sample event number and
the source of the sample event. Source refers to the programmed
or configured setting that initiated the sample event. For
example, the sampler will report “TIME” as a source if the
sample was taken as one of the program’s time-paced samples.
Eight sources are tracked and reported for a composite sampler:
Time - The sample event was one of the program’s time-paced
samples.
Flow - The sample event was one of the program’s flow-paced
samples.
Start - The sample event was initiated at the program’s start
time.
Resume - The sample event was initiated to compensate for a
missed sample which should have occurred while the sampler
was halted. If more than one sample event was missed, only one
sample will be taken.
Power - The sample event was initiated to compensate for a
missed sample which should have occurred while the sampler
was without power. If more than one sample was missed, only
one sample will be taken.
Enable - The sample event was initiated when the sampler
became enabled by a device connected to pin F of the flow meter
connector, generally an Isco Flow Meter or Liquid Level Actuator.
This source is also reported when the sample was initiated at a
programmed resume time. Two different configure option set-
3-61