1
Download IPM User Manual
Transcript
Control Protocol SetConfigEth Item Size (Bytes) Range of Values Description Message ID 2 AG_RCP_SET_CFG_ETH_MSG_ID Message Type 2 AG_RCP_CALL Message Length 2 16 Status 2 AG_RCP_ACK Interface 4 AG_IF_C AG_IF_A Interface to configure Speed 4 AG_RCP_ETH_RATE_10 AG_RCP_ETH_RATE_100 AG_RCP_ETH_RATE_AUTO Interface speed in Mbps, or determined using auto-negotiation Duplex Flag 4 AG_TRUE AG_FALSE If AG_TRUE, the next field will be interpreted Duplex Mode (optional) 4 AG_RCP_ETH_HALF_DUPLEX, AG_RCP_ETH_FULL_DUPLEX Sets the duplex mode to be half or full Usage Guidelines This message sets the Ethernet configuration. When this command configures an interface to operate using auto-negotiation, the interface will also be configured to use a PHY. All changes will go into effect only after a device reset, except for a change in the speed parameter. The response message indicates whether a reset is required or not. See “SetConfigEth Response” on page 4-51. RS-160 User’s Manual (Rev. 3) 4-11
