Download IPM User Manual

CLI Commands
SetBitstreamDynLpbk
Configures the bitstream interface for loopback operations until the next device reset
Abbreviation
sbdl
sbdl <loop-mode>
Syntax Description
<loop-mode>
{Local+Tx|Local|Remote+Rx|Remote|Dual}
Local: Transmitted traffic is looped back and received.
Remote: Received traffic is looped back and retransmitted.
Local+Tx: Transmitted traffic is looped back and received. It
is also transmitted externally.
Remote+Rx: Received traffic is looped back and retransmitted. It is also received by the RS-160 processor.
Defaults
Usage Guidelines
This command is for test and debug purposes only. Note that this command has an immediate effect.
Once a loopback mode is set it stays in place until the next device reset.
Examples
CM160:\Config\E1>sbdl local+tx
The command completed successfully.
3-88
RS-160
User’s Manual (Rev. 3)