Download NightView User`s Guide - Concurrent Software Portal
Transcript
NightView User’s Guide Solution: In the Debug Window, you should click on the Resume button. In the dialogue I/O area, NightView responds with something like the following: 1. Parent sleeping for 2. Parent sleeping for Child got ordinal signal 3. Parent sleeping for Child got ordinal signal 4. Parent sleeping for Child got ordinal signal 5. Parent sleeping for Child got ordinal signal Child got ordinal signal 2 seconds 2 seconds #1 2 seconds #2 2 seconds #3 2 seconds #4 #5 Because of the ignore count on breakpoint 8, the parent process sent only five out of ten signals to the child process before the breakpoint was hit. The source code is written so that the lines that begin with a number come from the parent process, and the lines that begin with the word "Child" come from the child process. The debug status area and the debug group area show the status Stopped at breakpoint 8. This means that the process hit breakpoint number 8. For the C program, NightView displays something like the following in the debug message area: local:15625: at Breakpoint 8, 0x10002950 in parent_routine( pid_t child_pid = 13504, int total_sig = 10) at parent.c line 16 $3: total_sig = 10 For the Fortran program, NightView displays something like the following in the debug message area: local:15625: at Breakpoint 8, 0x105d0 in parent_routine( INTEGER child_pid / 13504 / ) at parent.f line 17 $3: total_sig = 10 For the Ada program, NightView displays something like the following in the debug message area: local:15625: at Breakpoint 8, 0x30324 in parent_routine( child_pid : IN integer = 13504, total_sig : IN integer = 10) at parent.a line 15 $3: total_sig = 10 Initial lines show where execution stopped. One line shows the value of total_sig from the print command attached to breakpoint 8. Note that the order of the displayed lines may vary. 5-28
Related documents
NightView User`s Guide - Version 6.1
Samson Q5 Specifications
NightView User`s Guide - Concurrent Software Portal
NightView User`s Guide - Version 7.5
µC/CAN User`s Manual - Doc
Samson 215 Specifications
Vol 6 No 11
SH-2A, SH-2 E200F Emulator User`s Manual
SH7080-Series E200F Emulator Application Note
e2 studio 3.0.1.7 Release Note
NightTrace Manual
HDS-5x Quick Start Guide