Download NightView User`s Guide - Concurrent Software Portal
Transcript
NightView User’s Guide pattern A wildcard pattern to match against the executable file names of newly execed programs. See “Wildcard Patterns” on page 7-17. command A debugger command to be executed when a new program whose executable file name matches pattern is execed. In the third form of the on restart command, the debugger commands to be executed must begin on the line following the do keyword. The list of debugger commands to execute is terminated when a line containing only the words end on restart is encountered. The on restart command is primarily intended to be used internally by the debugger as part of the restart processing. See “Restarting a Program” on page 3-15. You may use on restart explicitly, if desired, but you should be wary of conflicts with the debugger's use. The debugger creates on restart commands as a result of a checkpoint. on restart is virtually identical to on program in form and function. See “on program” on page 7-39 for a description of the parameters and functionality of these commands. That section also describes the interaction of these two commands. If you wish to list all on restart commands, or see which on restart commands would be executed for a particular program name, use the info on restart command. See “info on restart” on page 7-134. checkpoint 7 Take a restart checkpoint now. checkpoint The checkpoint command saves restart information for the program running in each process in the qualifier. In most cases, you do not need to use the checkpoint command, because checkpoints are taken automatically at certain times. See “Restarting a Program” on page 3-15. checkpoint gives you a way to explicitly take a checkpoint at a time you choose. Note that any later checkpoints (either explicit or automatic) will replace the restart information. Example: In this example, you are debugging a complex program. You know some good places to set breakpoints, and you know that you need some more to find the bug, but are not sure yet where they should be. You set your known breakpoints, take a checkpoint, and save the restart information to a file. Then you experiment with some different breakpoints. (local) # set known good breakpoints (local) breakpoint fred.c:123 set other known breakpoints ... 7-42
Related documents
NightView User`s Guide - Version 6.1
Samson Q5 Specifications
NightView User`s Guide - Concurrent Software Portal
NightView User`s Guide - Version 7.5
µC/CAN User`s Manual - Doc
Samson 215 Specifications
Vol 6 No 11
SH-2A, SH-2 E200F Emulator User`s Manual
SH7080-Series E200F Emulator Application Note
e2 studio 3.0.1.7 Release Note
NightTrace Manual
HDS-5x Quick Start Guide