Download Stable32 User Manual - Hamilton Technical Services

Transcript
S T A B L E 3 2
U S E R
M A N U A L
•
Allan Variance
The non-overlapping Allan variance function calculates the original σy(τ) and the standard
deviation, and uses their ratio to estimate the noise type and the confidence interval of the
Allan deviation.
•
Overlapping Allan Variance
The overlapping Allan variance function also calculates and displays σy(τ), using fullyoverlapping samples. It also estimates the noise type, and uses that to determine the # of
degrees of freedom. It then establishes single or double-sided confidence intervals for the
Allan deviation based on a certain confidence factor.
•
Modified Allan Variance
The modified Allan variance function requests the averaging factor and bandwidth factor for
the measuring system, BW = 2πfhτ0, where fh is the upper cutoff frequency in Hz. It then
calculates σy(τ) and Mod σy(τ), and uses their ratio to estimate the noise type. This function
then continues with the determination of single or double-sided confidence intervals for the
modified Allan deviation for the estimated noise type and desired confidence factor.
•
Time Variance
The time variance is a measure of time stability based on the modified Allan variance.
•
Hadamard Variance
The non-overlapping Hadamard variance uses 3 (rather than 2) fractional frequency samples,
which allows it to converge for α = −3 (Flicker Walk FM) and α = −4 (Random Run FM)
noises, and causes it to be unaffected by linear frequency drift.
•
Overlapping Hadamard Variance
The overlapping Hadamard variance uses fully overlapping samples to calculate the
Hadamard variance.
•
Total Allan Variance
The total variance uses a double reflection method to form a σy(τ) estimate with better
confidence at long averaging times.
•
Total Modified Variance
The total modified variance also uses a double reflection method to form a mod σy(τ) estimate
with better confidence at long averaging times.
•
Total Time Variance
The total time variance is a measure of time stability based on the total modified variance.
•
TIE rms
The rms time interval error, TIE rms, is the rms value of the time deviations. It can be
calculated for phase data only.
184