Download Manual - Festo

1. Installation
1 Cables
1
2 Housing
3 Connecting part
4 Strain relief
4
2
3
Fig. 1/6: Preparing the connecting cable
Preparing the cables
When you have selected suitable cables, connect them as
follows (Fig. 1/6):
1. Loosen the centre knurled nut in order to open the socket.
2. Open the strain relief on the rear of the housing. Then
pass the cable through.
3. Remove 5 mm of the insulation and fit end sleeves onto
the wires.
4. Connect the conductors.
5. Insert the connecting part into the housing of the plug
again. Pull the cable back so that there are no loops inside the housing.
6. Tighten the strain relief.
Festo P.BE-CP-DN-EN en 0009a
1-11