Download WDMPsc Manual

Transcript
Maintenance
Figure 8 Cover to tray conversion
1
Tray arm (2x)
2
Cover/tray
5.4 Wiring connections for component replacement
DANGER
Disconnect power to the WDMP sc before performing all
electrical work.
The WDMP sc is supplied with a junction box for wiring
connections. The junction box is shielded by a cover that doubles
as a tray for calibration standards and reagents. The cover is
removed by sliding it up then pulling it away from the panel. Wiring
connections are shown in Figure 9 and Figure 10. To access the
wiring connections inside the junction box, remove the two screws
and open the hinged cover.
22